Specialty Welding — SAW
Sub Merged Arc Welding
High-deposition, automated arc welding beneath a protective flux blanket — built for thick-section structural steel, pressure vessels, and long production welds.
High-deposition welding for thick sections
Submerged Arc Welding strikes an arc beneath a continuously fed, granular flux blanket rather than in open air. The flux fully covers the arc and weld pool, virtually eliminating spatter, arc flash, and fume exposure while allowing significantly higher amperage — and therefore much higher deposition rates — than open-arc processes.
That combination of high deposition and a smooth, self-cleaning slag makes SAW our process of choice for heavy-plate structural steel, pressure vessel shells, and other applications where weld volume and repeatability matter as much as strength. The process is fully mechanized, holding travel speed, arc voltage, and wire feed to tight, repeatable tolerances across long production welds.
- Arc struck beneath a continuously-fed granular flux blanket
- High deposition rates for thick-section welding
- Smooth, spatter-free weld surface requiring minimal cleanup
- Fully mechanized for consistent, repeatable production welds
How a submerged arc weld is made
A mechanized, flux-shielded process built for heavy-section production welding.
Joint & Flux Bed Setup
The joint is prepared and a granular flux bed is laid ahead of the welding head.
Continuous Electrode Feed
A bare wire electrode feeds continuously into the flux-covered joint.
Arc Submersion Beneath Flux
The arc burns fully submerged beneath the flux, shielding it from the atmosphere.
High-Deposition Weld Pool Formation
High amperage drives a large, deep-penetrating weld pool at high deposition rates.
Slag Crust Formation & Removal
A protective slag crust forms over the weld and is removed after cooling.
Flux Recovery & Reconditioning
Unfused flux is vacuum-recovered, screened, and reconditioned for reuse.
Equipment behind every submerged arc weld
High-amperage, mechanized hardware built for heavy-plate production welding.
SAW Power Source
High-amperage power source sized for thick-section deposition rates.
Flux Hopper & Delivery System
Meters and applies granular flux ahead of the welding head.
Continuous Wire Electrode Feed
Bare wire electrode feed sustaining high-deposition welding.
Flux Recovery Unit
Vacuum recovery and reconditioning of unfused flux for reuse.
Mechanized Travel Carriage
Automated travel holding speed and position across long welds.
Seam Tracking & Joint Alignment System
Keeps the welding head aligned to the joint on long or curved seams.
Process capability at a glance
Where submerged arc welding goes to work
Pressure Vessel Shells & Heads
High-deposition longitudinal and circumferential seams on vessel shells.
Structural Steel Plate Fabrication
Heavy-plate structural welds requiring consistent, repeatable quality.
Storage Tank Fabrication
Long production welds on tank shells, floors, and roof plate.

